vSphere configuration
using Dell EMC Fibre Channel SAN
If you use Fibre Channel storage, you can connect
a single Fibre Channel Host Bus Adapter (HBA) to a Fibre Channel switch
that provides paths to both the storage controllers on the Fibre Channel
storage unit. To provide maximum protection against a single failure
at the HBA, Fibre Channel switch, or SP level, Dell EMC recommends that
you use two Fibre Channel HBAs on the ESXi host connected to separate
Fibre Channel switches. The Fibre Channel switches provide redundant
paths to the storage controllers on the storage unit. The following
figure shows the vSphere configuration using Fibre Channel SAN.
Figure 1. Configuring vSphere using Dell EMC Fibre Channel SAN
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\