The ESXi 6
kernel supports IPv4, IPv6, and IEEE 802.1Q (VLAN tagging) for all
management network connections. Configuration of parameters including
IP address, gateway, subnet mask, host name, and DNS systems occurs
through the DCUI.
Press F2 in the main ESXi host screen that
is displayed after your system boots.
The Authentication Required screen is displayed.
Type your log in credentials and press Enter.
Select Configure Management Network in the main DCUI customization screen, and press Enter.
The Management network configuration screen is displayed.
For the PowerEdge M-series modular systems
enabled with FlexAddress:
Ensure that the variable Net.FollowHardwareMac is set to 1.
Use the vSphere Client to connect to the
ESXi host.
Navigate to Configuration > Software > Advanced Settings > Net.
Set Net.FollowHardwareMac to 1 and reboot the ESXi host.
Back up your configuration settings. For more
information, see the Configuration back up and restore procedures
section.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\