Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

VMware vSphere ESXi 6.x on Dell EMC PowerEdge Systems Installation Instructions and Important Information Guide

PDF

Installing ESXi on flash media

After installing the SD card in your system, locate the ESXi installer media that you had created in Download Dell EMC customized ESXi image.
To install ESXi on the flash media, complete the following steps:
NOTE: For more information about supported configurations of the PowerEdge servers with the SD memory card, see the VMware vSphere 6 on Dell EMC PowerEdge Servers Compatibility Matrix at www.dell.com/virtualizationsolutions.
NOTE: For instructions to install the SD memory card on the system board for supported PowerEdge servers, see the system-specific Owner's Manual or Information Update at https://www.dell.com/poweredgemanuals.
  1. Turn on the system.
    NOTE: Before installing ESXi, enable the flash storage device. For more information, see Enabling or Disabling Internal SD card.
  2. Insert the ESXi installer media into the optical drive.
  3. Restart the system.
  4. When the Dell EMC logo is displayed, press F11 immediately.
  5. At the Boot Menu, use the up- and down-arrow keys to select the optical drive and press Enter.
    The installer environment starts. When the installer image loads, the system is ready to begin the flash storage imaging process.
    CAUTION: Step 6 deletes all data on SD storage device.
  6. On the Select a Disk page, select the SD storage device on which you want to install ESXi and press Enter.
  7. Enter the root password and press F11 to start the installation.
  8. When the installation process is complete, press Enter to restart the system.
  9. When the Dell EMC logo is displayed, press F11 immediately.
  10. At the Boot Menu, use the up- and down-arrow keys to select the SD storage device, and then press Enter.
    The system boots and starts ESXi.
  11. To enable recurring boot, see Configuring boot sequence to ESXi.
  12. Set the correct licensing mode.
    For more information, see Licensing information.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\