- Notes, cautions, and warnings
- Introduction
- Installing vSphere 6.0
- Download Dell EMC customized ESXi image
- Installing, Enabling and Disabling ESXi
- Overview - Dell NUMA Fault Resilient Memory
- Enable Dell NUMA Fault Resilient Memory
- Overview - Dell Fault Resilient Memory
- Enabling Dell Fault Resilient Memory
- Installing ESXi on flash media
- Installing ESXi on the hard drive
- Installing ESXi on the BOSS-S1 device
- Enabling or Disabling Internal SD card
- Configuring one-time boot to ESXi
- Configuring boot sequence to ESXi
- Downloading patches and updates for ESXi
- Creating vCenter Server installation media
- Installing vCenter Server
- Deploying vSphere 6.0
- Configuration back up and restore procedures
- Licensing information
- Troubleshooting ESXi
- Getting help
VMware vSphere ESXi 6.x on Dell EMC PowerEdge Systems Installation Instructions and Important Information Guide
Creating a virtual disk with the BOSS-S1 device
- Turn on the system.
- Press F2 to enter System Setup, and then .
- Select the Create RAID configuration option.
- Select the two M.2 SATA physical disks displayed, and then click Next to proceed to next page.
- Choose the appropriate options as required, and type the name for the virtual disk.
- Select Yes for Would you like to create virtual disk option? and then click Next to proceed to next page.
Virtual disk is created successfully and you can verify the virtual disk information at the . The created virtual disk is displayed in the Virtual Disk Info.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\