- Notes, cautions, and warnings
- Introduction
- Installing vSphere 6.0
- Download Dell EMC customized ESXi image
- Installing, Enabling and Disabling ESXi
- Overview - Dell NUMA Fault Resilient Memory
- Enable Dell NUMA Fault Resilient Memory
- Overview - Dell Fault Resilient Memory
- Enabling Dell Fault Resilient Memory
- Installing ESXi on flash media
- Installing ESXi on the hard drive
- Installing ESXi on the BOSS-S1 device
- Enabling or Disabling Internal SD card
- Configuring one-time boot to ESXi
- Configuring boot sequence to ESXi
- Downloading patches and updates for ESXi
- Creating vCenter Server installation media
- Installing vCenter Server
- Deploying vSphere 6.0
- Configuration back up and restore procedures
- Licensing information
- Troubleshooting ESXi
- Getting help
VMware vSphere ESXi 6.x on Dell EMC PowerEdge Systems Installation Instructions and Important Information Guide
Configuring the password
You can use DCUI to change the password for the administrator account. The administrative user name for the ESXi 6 host is root.
To change
the password:
- Press F2 in the main ESXi Server host screen that is displayed
after your system boots.
The Authentication Required screen is displayed.
- Select Configure Password and then press Enter.
- Enter the old and new passwords.
If the password is accepted, the main DCUI screen is displayed. The new password is now set.
- Press Esc to log out.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\