To boot your
system to ESXi, complete the following procedure. Once the internal
flash device port is enabled, your system continues to boot to ESXi.
Turn on your system.
The Dell EMC logo is displayed.
Press F2 to open the System Setup page.
After you complete the system boot, the System BIOS configuration menu is displayed.
Using the up- and down-arrow keys, select Hard-Disk Boot Sequence, and then select the relevant boot
device.
Press the hyphen key (-) to move up the relevant boot device in the order.
CAUTION:Dell EMC recommends that you do not modify other settings
unless you are familiar with the settings. Modifying settings could
cause your system to fail to boot or function properly.
Press Enter, and follow the on-screen procedure to
save these changes.
Restart your system.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\