This section
provides the Linux commands you can use to start, stop, or restart
OMSA and the network service. At the terminal command prompt, type
the commands listed in the following tables to perform the required
functions.
NOTE: You can run these commands using the root privileges.
Table 1. OMSA service
commandsOMSA service
commands
Command
Description
srvadmin-services.sh start
Start the OMSA service.
srvadmin-services.sh stop
Stop the OMSA service.
srvadmin-services.sh restart
Restart the OMSA service.
srvadmin-services.sh status
Status of the OMSA service.
Table 2. Network service
commandsNetwork service
commands
Command
Description
service network start
Start the network service.
service network stop
Stop the network service.
service network restart
Restart the network service.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\