Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Unisphere and Unisphere Central 2020 R1 Administrator's Guide

PDF

Add a Controller

This step-by-step wizard guides you through adding a new controller to the storage system.

Prerequisites

  • This wizard is only available for SC4020, SC8000, and SC9000 controllers.
  • The new controller must have a Hardware Serial Number (HSN) and Eth 1 IP address assigned to it before starting this procedure. To see the new controller information, run the following command from the serial console:
    controller show

Steps

  1. If you are connected to a Data Collector, select a Storage Center from the drop-down list in the left navigation pane of Unisphere Central.
  2. From the System iconSYSTEM menu, click Hardware.
    The Hardware view is displayed.
  3. Click the System tab.
  4. In the System tab navigation pane, click Controllers.
    The Controllers view is displayed.
  5. Click Add Controller.
    The Add New Controller wizard opens.
  6. Confirm the details of your current install, and click Next.
  7. Insert the controller into the existing enclosure. Click Next to validate the install.
  8. Click Finish to exit the wizard.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\