SCv2000 and SCv2020 Storage System Owner’s Manual

Start Up the Storage Controller

If the storage controller was previously shut down, perform this procedure to start it up.

1. Plug the power cables into the power supply/cooling fan modules of the storage system.
2. Turn on the storage system by pressing the power switches on the power supply/cooling fan modules.
   NOTE When the storage system is powered on, a one-minute delay occurs while the SCv2000/SCv2020 prepares to boot. During this time, the only indication that the SCv2000/SCv2020 is powered on are the LEDs on the storage controllers. After the one-minute delay, the SCv2000/SCv2020 fans and LEDs turn on to indicate that the storage system is starting to come up.
3. Use the Dell Storage Manager to make sure that the replacement part is recognized and shown as up and running.