In the MPIO Devices tab, click Add, enter the Device hardware
ID of the device you want to add MPIO support for, and then click OK.
The device hardware IDs are listed in the Discover Multi-Paths tab.
NOTE: A device hardware ID is a combination of vendor’s name and a product
string that matches the device ID that is maintained by MPIO in its
supported device list. The vendor and product IDs are provided by
the storage provider, and they are specific to each type of hardware.
In the DSM Install tab, type the DSM INF file and click Install or uninstall to install or Uninstall a DSM.
In the Configuration Snapshot tab, capture the snapshot of the current MPIO configuration on the
system, specify a filename for the information to be captured, and
then click Capture.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\