Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell Solutions Enabler 10.1.0 Installation and Configuration Guide

PDF

The SEMLB interface

About this task

After the #07DFLTS job has run, the SEMLB interface can be used to set the lockbox password. To do this, follow these steps:

Steps

  1. Navigate using the ISPF option 3.4 to the installation RIMLIB, locate the member SEMLB, and then use exec to execute it. The following panel is displayed: Solutions Enabler Stable System Values Reset
  2. Select option 1. The following panel is displayed: Solutions Enabler Stable System Values Reset
  3. Do one of the following:
    • If you ran the lockbox step in #07DFLTS, then enter the default password and press Enter. The Stable System Values will be reset.
    • If you did not run the lockbox step in #07DFLTS, then enter a new password and press Enter. The Stable System Values will be set and the new password will now be in effect.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\