- Notes, cautions, and warnings
- Preface
- Installation prerequisites
- Installation
- Installing Solutions Enabler on UNIX and Linux
- Installing Solutions Enabler on Windows
- Installing Solutions Enabler on z/OS
- UNIX Native installation
- Uninstalling Solutions Enabler
- Post-Installation configuration for UNIX, Windows, and z/OS
- eLicensing
- Initial post-installation configuration of Solutions Enabler
- Setting the CLI path
- Setting the online help path
- Managing database and gatekeeper locking
- Avoidance and selection files
- Changing the default behavior of SYMCLI
- Setting up daemons for distributed application support
- Managing the base daemon
- Setting up the event daemon for monitoring
- RedHat Enterprise Linux 6.0/6.2 [GA] - x86_64 installation
- Backing up devices
- Adding the SSL certificate
- Vendor SNIA libraries needed for HBA information
- z/OS Post installation configuration
- Remote Operations
- Technical Notes and Configuration
- Gatekeeper Device Configuration
- Host specific behaviour running Solutions Enabler
- Solutions Enabler Directories
- UNIX Installation Log Files
Dell Solutions Enabler 10.1.0 Installation and Configuration Guide
Stopping the base daemon
To stop the base daemon, use the following command:
stordaemon shutdown storapid | all [-wait Seconds] [-immediate] [-abort]
Specifying all as the DaemonName will stop all of the daemons currently running.
If there are applications with connections to the base daemon, you can use the -immediate option to shut it down immediately; otherwise, it will not shutdown until the applications are done using it.
The -abort option sends a KILL signal, instead of asking the base daemon to shut itself down. Only privileged users (root) can use this option. (Supported on UNIX only.)
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\