- Notes, cautions, and warnings
- Preface
- Installation prerequisites
- Installation
- Installing Solutions Enabler on UNIX and Linux
- Installing Solutions Enabler on Windows
- Installing Solutions Enabler on z/OS
- UNIX Native installation
- Uninstalling Solutions Enabler
- Post-Installation configuration for UNIX, Windows, and z/OS
- eLicensing
- Initial post-installation configuration of Solutions Enabler
- Setting the CLI path
- Setting the online help path
- Managing database and gatekeeper locking
- Avoidance and selection files
- Changing the default behavior of SYMCLI
- Setting up daemons for distributed application support
- Managing the base daemon
- Setting up the event daemon for monitoring
- RedHat Enterprise Linux 6.0/6.2 [GA] - x86_64 installation
- Backing up devices
- Adding the SSL certificate
- Vendor SNIA libraries needed for HBA information
- z/OS Post installation configuration
- Remote Operations
- Technical Notes and Configuration
- Gatekeeper Device Configuration
- Host specific behaviour running Solutions Enabler
- Solutions Enabler Directories
- UNIX Installation Log Files
Dell Solutions Enabler 10.1.0 Installation and Configuration Guide
Installing Solutions Enabler on Windows
You can install/upgrade Solutions Enabler on a Windows host using the InstallShield wizard (described below), the command line (refer to Using the command line), or a response file (refer to Using a response file).
NOTE:
Solutions Enabler V10.1 is fully upgradeable. That is, you do not have to remove the previous version before installing V10.1.
NOTE:
Before starting this procedure, review the pre-install considerations in Installation prerequisites.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\