The entries in the control table are mostly VER statements and REP statements grouped together respectively. A VER or VERIFY statement is composed of the command phrase VER, a hexadecimal address and an eight-byte hexadecimal value. The following is an example:
VER 0001D8 0000,0000
The VER statement checks to see if the value at the address given is the same as the value provided in the statement. If true, then the following statement will be executed. If not, the following statements will be ignored and job
#12CNTRL will quit.
A REP statement is composed of the command phrase REP, a hexadecimal address and an eight-byte hexadecimal value. The following is an example:
REP 0001D8 0000,0001
The REP statement replace the current value at the given address with the value provided in the statement.
NOTE:
HINT: Make a copy of member
#12CNTRL for backup purposes before making any changes.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\