Starting from 10.5.3.0 release, from SFS UI, you can configure L3 VLAN network for the racks to which the servers are connected. Using this feature, you can create a L3 VLAN network for each VLT pair (rack) with a different subnet. This network is used for NSX-T overlay to create VTEP networks. Create, edit, and delete multirack L3 VLAN networks from SFS UI. You can specify IP address for each switch in a rack when creating a multirack L3 VLAN.
Create multirack L3 VLAN
Use the following procedure to create a multirack L3 VLAN:
Click
Network.
Click
Networks >
Multi-Rack L3 VLAN.
Click
Create.
Enter the following details:
Network ID. For example, overlay.
Network name.
VLAN ID—A number from 1 through 3999 (except 3939). For example, 2713.
Description.
Select the
Specific IP Addresses checkbox to specify the IP address for each switch.
Enter the following details specific to the rack:
IP addresses of the individual switches
Prefix length
Gateway IP address
Helper IP addresses
Click
Create.
The system displays VLAN network creation success message.
Edit multirack L3 VLAN
Select a network ID from the list and click
Edit.
Edit the configuration as necessary.
Click
Edit.
The system displays edit network success message.
Delete multirack L3 VLAN
Select the VLAN network to remove and click
Delete.
Click
Delete to confirm.
The system displays network deletion success message.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\
