Revision history
The following table provides an overview of the changes to this guide from a previous version.
Table 1. Revision history Revision history
Revision
Date
Revision summary
A18
2024-05-15
Added the following section:
Upgrade sequence for SmartFabric OS10 platforms .
A17
2024-03-12
Updated the Supported upgrade paths section.
Perform an OS10 upgrade—Updated the VLAN configuration guidelines. Starting from Release 10.5.5.x, the uppercase 'V' in VLAN within
startup.xml is no longer supported.
image install CLI—Updated the image installation process for the same and different image types.
A16
2023-07-07
The
image install
file-url [downgrade-config-file
downgrade-config-file-name ] command allows you to downgrade the SmartFabric OS10 software to Release 10.5.5.5 or later and apply the saved configuration data corresponding to a downgraded image version. Supported for downgrading up to two previous major OS10 versions. For example, if the running version is 10.5.8.x, you can downgrade until Release 10.5.6.x.
A15
2023-05-12
A14
2023-04-06
Support for Dell Upgrade Package (DUP) in OS10 release 10.5.5.0P1 for the following platforms:
S4100-ON Series
S5200-ON Series
S5448F-ON
Z9264F-ON
Z9332F-ON
Z9432F-ON
Z9664F-ON
A13
2022-10-14
Updated the Upgrade PCIe firmware from OS10 hshell section
Added link to the Dell Technologies Innodisk 3IE3 Solid State Drive ONIE Firmware Updater Release Notes
A12
2022-09-28
Updated the Upgrade PCIe firmware from DIAG OS section
Updated the Upgrade PCIe firmware from OS10 hshell section
A11
2022-08-17
Added the following topic: Verify OS10 image.
Added an important note for SFS deployments in the following section: Supported upgrade paths—SFS mode deployments.
A10
2022-06-27
Added the following section: Upgrade or downgrade OS10 image on secure boot-enabled nodes.
A09
2022-03-07
Added a prerequisite for VLT minimum traffic loss upgrade in the Platform-specific prerequisites section.
A08
2022-02-28
Dell Technologies branding and minor terminology modifications are made throughout the guide.
A07
2021-12-07
Added links to the PowerSwitch S5448F-ON platform documentation in Appendix D.
A06
2021-11-09
Added information about startup configuration information during upgrade and downgrade.
A05
2021-10-12
Updated the following sections:
Supported upgrade paths—Full switch mode deployments
Supported upgrade paths—SFS mode deployments
Added the Update ONIE and ONIE Firmware section.
A04
2021-08-27
Removed the note about upgrading SmartFabric OS10 on the Z9100-ON switch from the Upgrading OS10 software section.
A03
2021-07-29
Updated the Supported upgrade paths-Full switch mode deployments section with the procedure to upgrade from 10.4.2.x or earlier releases.
A02
2021-07-13
Updated the Supported upgrade paths section.
Added PCIe upgrade instructions for S5200-ON platforms.
Added links to the ONIE Firmware Updater and DIAG OS Release Notes.
A01
2021-07-02
Added the following:
Information about certificate expiry and prerequisites.
S4100-ON platform-specific prerequisites.
FAQs
A00
2021-03-04
Initial release.
Data is not available for the Topic
All fields are required unless marked otherwise.
Comments cannot contain these special characters: <>()\
Sorry, our feedback system is currently down. Please try again later.
Thank you for your feedback.