- Notes, cautions, and warnings
- Introduction
- New and enhanced features
- Dashboard
- Devices
- Methods of adding devices
- Add a chassis
- Add an iDRAC
- Add a networking device
- Add a server or hypervisor
- Add a software
- Add a virtual machine
- Add a converged or hyperconverged infrastructure appliance
- Add a data storage device
- Add a direct liquid cooling device
- Add a data protection device
- Deep discovery
- Maintenance mode overview
- Inventory validation
- Device correlation
- Enable or disable remote access
- Device discovery rules
- Adapters
- Device groups
- Device credentials and credential profiles
- Service requests
- Telemetry
- Extensions
- Audits
- Configuring Secure Connect Gateway settings
- Configuring alert and event settings
- Updating Secure Connect Gateway
- Secure Connect Gateway resources
- Contacting Dell Technologies
Secure Connect Gateway 5.x — Virtual Edition User's Guide
Configure SMTP server settings
Prerequisites
About this task
NOTE:
- When you go to the Configure SMTP server settings page for the first time while you are logged in, an SMTP server connectivity test is performed automatically to check the connectivity status. A success or failure message is displayed after the completion of the test.
- If you close the banner on the secure connect gateway user interface that informs you about withdrawal of support for TLS 1.0 and 1.1, the automatic connectivity test is not performed when you go to the Configure SMTP server settings page.
Steps
- Go to .
- Enter the hostname or IP address and port number of the SMTP server.
- If the SMTP server requires authentication, enable the option to enter the details and enter the username and password to access the proxy server.
-
Enter up to 10 email recipients and the sender email address that must be used to send the email messages from
secure connect gateway.
NOTE:You must add the correct domain to avoid emails being filtered as spam. It is recommended that you use your own domain to send the emails. You can also register the SMTP server with dell.com or emc.com to send your emails.
-
Test the connection and then click
Apply.
If the connection is successful, a confirmation email is sent to all the email recipients that you provided.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\