All the devices that are inventoried in
secure connect gateway are automatically assigned to the
Default device group. Depending on your requirement, you can group your devices to manage them better.
Steps
Go to
Device management > Manage device groups > Create group.
The
Create group page is displayed.
Enter a group name and description.
To provide primary or secondary contact details applicable for the devices in the group, select the
Contact Details check box and then enter the required details. To copy the details provided on the
Preferred contact and shipping details page, click the link that is displayed below the check box.
Click
Next.
The
Parts replacement (optional) section is displayed.
To provide the shipping contact and address details applicable for the servers in the group, enable the option to automatically receive replacement parts. Click the link that is displayed to copy the details provided on the
Preferred contact and shipping details page.
NOTE:Parts dispatch is supported only for devices that have an active ProSupport, ProSupport Plus, ProSupport One, or ProSupport Flex service entitlement.
If you selected
Canada or
United States as the country or region for shipping replacement parts, click
Validate address.
If the address is validated,
Create group is enabled.
If the address is not valid, possible addresses are displayed. Select the correct address and click
Continue or click
Go back and modify the address.
Click
Create group.
Results
The device group is created and displayed on the
Device groups page.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\