PowerFlex Manager supports replacement of faulty NVDIMM and NVDIMM batteries.
About this task
This capability is available on the
PowerFlex appliance and
PowerFlex rack offerings only.
Steps
On the menu bar, click
Lifecycle > Resource Groups.
On the
Resource Groups page, select a resource group and click
View Details in the right pane.
Scroll down to the
Physical Nodes section of the page.
Under
Physical Nodes, click
NVDIMM Replacement.
PowerFlex Manager displays the
Node List panel in the
NVDIMM Replacement wizard.
Click
Next.
PowerFlex Manager displays the
Select Component panel. All the available NVDIMMs are displayed under the
NVDIMM header while the available NVDIMM batteries are displayed under
NVDIMM Battery.
Select the NVDIMM or battery that you want to replace.
A message is displayed prompting you to ensure that the node selection is correct as the NVDIMM replacement process is irreversible.
Enter
REMOVE NVDIMM and click
Confirm to proceed with the NVDIMM replacement. To replace an NVDIMM battery, enter
REMOVE NVDIMM BATTERY.
A message stating the removal or addition of the NVDIMM or battery, with the node and slot numbers, is displayed on the
Resource Groups page. The status of the resource group and the individual node is "In Progress". The log details are also displayed in the
Recent Activity section on the right side of the page.
A job for the replacement of the battery is created. Click the jobs icon at the upper right hand-side of the menu bar to view the details of the job.
After the NVDIMM or battery is replaced, the host and SVM are turned off. After the physical replacement of the NVDIMM and the battery, the status of the host and node on the
Resource Groups page display service mode. Also, the option
Discover Replacement NVDIMM is displayed on the page. When the NVDIMM is replaced physically, click
Discover Replacement NVDIMM. The
Discover Replacement NVDIMM turns on the node and does a system erase of the NVDIMMs. On completion of the discovery, the log displays the status as "Complete" and the option
Complete NVDIMM Replacement is displayed.
Click
Complete to complete the replacement process.
After the NVDIMM is replaced, you can create virtual hardware for the NVDIMM device, remove the SDS from maintenance or service mode, and turn on the SVM.
After the new NVDIMM node or battery is added, a message indicating the completion of the NVDIMM node or battery is displayed on the
Resource Groups page. And,
Dismiss option is displayed for dismissing the task.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\