You can remove a software management node that is no longer required.
PowerFlex Manager supports both the deletion and removal of a software management resource group.
About this task
You can choose to perform either of the following actions:
Delete the software management resource group, which deletes deployment information and also makes required configuration changes to remove the PowerFlex storage. If you choose the delete option, the PowerFlex packages that are installed during deployment, the PowerFlex repositories that are created during the deployment, and the http share certificates are removed. The operating system and networking are left intact.
Remove the software management resource group, which removes the deployment information for the software management resource group without making any configuration changes to the deployed components.
If the
PowerFlex gateway used in the resource group is being updated on the
Resources page.
PowerFlex Manager also does not allow you to delete a resource group.
If the role you were assigned to at deployment time enables you to deploy resource groups, you can delete the resource groups that you deployed.
Steps
From the
PowerFlex Manager menu, click
Lifecycle > Resource Groups.
Select the software management resource group.
On the
Resource Group Details page, under
More Actions, click
Remove Resource Group.
In the
Remove Resource Group dialog box, select the
Resource group removal type.
If you choose
Remove Resource Group, perform the following steps:
To keep the nodes in the inventory, select
Leave nodes in PowerFlex Manager inventory and set state to and select the state:
Managed
Unmanaged
Reserved
To remove the nodes, select
Remove nodes from the PowerFlex Manager inventory.
Click
Remove.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\