PowerFlex Manager enables you to change the MDM role for a node in a
PowerFlex cluster. For example, if you add a node to the cluster, you might want to switch the MDM role from an existing node to the new node.
About this task
You can launch the wizard for reconfiguring MDM roles from the
Resource Groups page or from the
Resources page. The nodes that are listed and the operations available are the same regardless of where you launch the wizard.
Each fault set can have a maximum of one MDM role (management or tiebreaker).
PowerFlex Manager blocks your role assignments if the reconfigured roles do not conform to
PowerFlex best practices.
Steps
To access the wizard from the
Resource Groups page:
On the menu bar, click
Lifecycle > Resource Groups.
Select a resource group that has the
PowerFlex gateway for which you want to reconfigure MDM roles.
In the right pane, click
View Details.
The
Resource Group Details page is displayed.
On the
Resource Group Details
page, click
Reconfigure MDM Roles under
More Actions.
The
MDM Reconfiguration page is displayed.
To access the wizard from the
Resources page:
On the menu bar, click
Resources.
Select the
PowerFlex gateway for which you want to reconfigure MDM roles.
In the right pane, click
View Details.
The
Details page is displayed for the selected
PowerFlex gateway.
On the
Details
page, click
Reconfigure MDM Roles.
The
MDM Reconfiguration page is displayed.
Review the current MDM configuration for the cluster.
Find each MDM role that you want to reassign and choose the new Host Name or IP address for the role in the
Select New Node for MDM Role list.
You can reassign multiple roles at one time.
Click
Next.
The
Summary page is displayed.
Type
CHANGE MDM ROLES to confirm your changes.
Click
Finish.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\