Dell PowerFlex 4.5.x Administration Guide

Map RCG target volumes to hosts

Designate which hosts can access the RCG from the target volumes.

1. On the menu bar, click Protection > RCGs.
2. In the Map RCG Target Volume dialog box, click the relevant RCG check box, and click Mapping > Map.
3. Select one or more volumes on the left and click >> to add them to the selection list on the right.
   Optionally, filter the list of the volumes by entering a search string in the Filter box.
4. Click Next.
5. Select the host(s) that you want to map to the selected volumes.
   Optionally, filter the list of the hosts by entering a search string in the Filter box.
6. Click Next.
7. Assign the Access Mode to the hosts that will be mapped to the target volumes.
   1. To assign the Read Only mode to a set of mappings, select the mappings and click Read Access at the top of the page.
   2. To assign the No Access mode to a set of mappings, select the mappings and click No Access at the top of the page.
   NOTE:Read Access mode applies to all platforms, except Windows clusters, which require the No Access mode.
8. Click Finish.