Once
PowerFlex Manager is configured, you can use it to manage the system.
The following table describes common tasks for managing system components and what steps to take in
PowerFlex Manager to initiate each task:
If you want to...
Do this in
PowerFlex Manager...
View network topology
Click
Lifecycle > Resource Groups.
On the
Resource Groups page, select a resource group.
On the
Resource Group Details tab, click the
Port View tab.
Run inventory (nodes, switches,
PowerFlex gateway, and VMware vCenter cluster)
Click
Resources and click the
All Resources tab.
Click the check box for the resource you want to update and then click
Run Inventory.
After running the inventory, click
Update Resource Group Details under
More Actions on the
Resource Groups page for any resource group that requires the updated resource data.
Add an existing resource group
Click
Lifecycle > Resource Groups and click
+Add Existing Resource Group.
Be sure to upload a compliance file (if necessary), define the networks, and discover resources before adding the existing resource group.
Perform node expansion
Click
Lifecycle > Resource Groups. On the
Resource Groups page, select a resource group.
On the
Resource Group Details tab, under
Add Resources, click
Add Nodes.
The procedure is the same for new resource groups and existing resource groups.
Remove a node
Click
Lifecycle > Resource Groups.
On the
Resource Groups page, select a resource group.
On the
Resource Group Details tab, under
More Actions, click
Remove Resource.
Select
Delete Resource for the
Resource removal type.
Enter service mode (applicable for
PowerFlex appliance and
PowerFlex rack only)
Click
Lifecycle > Resource Groups.
On the
Resource Groups page, select a resource group.
On the
Resource Group Details tab, under
More Actions, click
Enter Service Mode.
Exit service mode (applicable for
PowerFlex appliance and
PowerFlex rack only)
Click
Lifecycle > Resource Groups.
On the
Resource Groups page, select a resource group.
On the
Resource Group Details tab, under
More Actions, click
Exit Service Mode.
Replace a drive
Click
Lifecycle > Resource Groups.
On the
Resource Groups page, select a resource group.
Under
Physical Nodes, click
Drive Replacement.
Reconfigure MDM roles
Click
Lifecycle > Resource Groups.
On the
Resource Groups page, select a resource group.
On the
Resource Group Details tab, click
Reconfigure MDM Roles under
More Actions.
You can also reconfigure MDM roles from the
Resources page. Select a
PowerFlex gateway and click
View Details. Then, click
Reconfigure MDM Roles.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\