Dell PowerFlex 4.5.x Administration Guide

PDF

Exporting a configuration report for all resources and resource groups

About this task

You can download a PDF report that lists configuration details for all resources and resource groups.

The configuration report shows the result of various configuration checks that PowerFlex Manager performs against the system. You can use the report to troubleshoot your resources and resource groups.

The report shows the following kinds of information:


Column name	Description
Resource Name	Provides the name of the resource for which the checks have been run. This column corresponds to the Resource Name shown on the Resources page.
Asset/Service Tag	Provides the asset or service tag of the resource for which the checks have been run. This column corresponds to the Asset/Service Tag shown on the Resources page.
Management IP	Specifies the Management IP of the resource for which the check is run. For a PowerFlex cluster, the management IP address is the MDM cluster IP address. For a PowerFlex gateway, the management IP address is the PowerFlex gateway IP address.
Result	Shows the result of the check (`PASS` or `FAIL`).
Severity	Indicates the severity of the check. The severity is based on the result. The severity levels are INFO, WARNING, HIGH, or CRITICAL. If the result is PASS, the severity is INFO. If the result is FAIL, the severity depends on the type of check. PowerFlex Manager supports only CRITICAL checks.
Details	Provides a description of the check that was run.
Affected Resources	Gives a list of the IP addresses or unique identifiers of resources that are impacted by the check. The list of affected resources helps with troubleshooting.

Steps

On the menu bar, click Resources.
Click Export Report.
Select Export Configuration PDF Report from the drop-down list.

The selected report downloads.