Add a replication pair to an RCG
Add a replication pair to an existing replication consistency group (RCG).
Steps
-
On the menu bar, click
.
-
Click the relevant RCG check box, and then click
.
-
In the
Add Pairs wizard, perform the following:
-
On the
Provisioning Type page:
- If you have not defined volumes to receive replicated data in the target system, select
Auto Provisioning.
- If you have already defined volumes to receive replicated data in the target system, select
Manual Provisioning.
-
For auto provisioning only, on the
Replication Pairs page, perform the following:
- Click the desired volume in the
Source column.
- Select a type:
Thick or
Thin.
- Select a storage pool from the target system.
- Click
Add Pair. The volume pair is added.
- Click
Next.
- On the
Map Volumes page, select a volume on the target side.
- Select a host to which to map the volume.
- Click
Next, and go to step 3d.
- Click
Next.
-
For manual provisioning only, on the
Replication Pairs page, perform the following:
- Select the desired volume in the
Source column, and then in the
Target column, select the target volume (only volumes of the same size are displayed).
- Click
Add Pair. The volume pair is added.
- Click
Next.
-
On the
Summary page, ensure that the correct source and volume pair are defined, and click
Add Pairs.
-
Optionally, at the top right of the window, click the
Running Jobs icon, and check the progress of the initial copy state.
-
Verify that the operation has finished and was successful, and then click
Dismiss.
Data is not available for the Topic