Configure the
PowerFlex management platform networking interfaces
Use the following procedure to complete the steps to configure the networking files for the
PowerFlex management platform cluster VMs.
About this task
NOTE:
For a multi-VLAN or multi-subnet configuration, the PowerFlex management controller management must be configured on PowerFlex management controller management (130).
For standard builds without multi-VLAN or multi-subnet configuration, can be on either VMware ESXi management (105) or PowerFlex management controller management (130).
NOTE:Based on your requirement, configure only the required interfaces on the management VMs. If you have unused interfaces on the deployed management VMs, then ensure you disconnect those interfaces within the vCenter. For example, an out-of-band interface. If the unused interfaces are connected and unconfigured, then PowerFlex Manager may display unexpected errors.
Steps
Launch the web console from the Virtual Machine Manager, log in as
delladmin.
Configure the
flex-node-mgmt-<vlanid> eth0 interface: