Configure LDAP authorization on the
PowerFlex Gateway
Use the following task to prepare the
PowerFlex Gateway and configure LDAP authorization on a
PowerFlex Gateway.
Prerequisites
Ensure the following:
The
PowerFlex Gateway host can establish a TCP connection to the LDAP server's address.
Each LDAP server has a separate base DN.
About this task
You can configure up to eight LDAP servers. When adding multiple LDAP servers, ensure that the list for each parameter in the
reset_ldap_properties command is the same length. Items in lists should be separated by ";". When multiple LDAP servers are used, you must import each server's certificate into the gateway's truststore, as described in the previous task.
NOTE:The
FOSGWTool --set_ldap_properties command that existed in previous
PowerFlex versions has been deprecated, and is now supported for only a single LDAP server. You cannot use it to add multiple LDAP servers.
Steps
In FOSGWTools, run the
--reset_ldap_properties command to add the LDAP parameters to the
PowerFlex Gateway.
If a previous LDAP configuration exists, an error message is returned. To confirm overwriting of the configuration, issue the command again, with the flag
--i_am_sure appended to the command.