- Notes, cautions, and warnings
- PowerFlex LDAP
- PowerFlex authentication and user roles
- Command authorization
- Preparing PowerFlex nodes for use with LDAP
- Configuring LDAP authentication on the PowerFlex MDM
- Configuring LDAP authentication on the PowerFlex Gateway
- Configuring LDAP authorization on the LIA
Dell PowerFlex v3.6.x User Roles and LDAP Usage Technical Notes
Changing LIA authentication to LDAP
Use the following procedure to change the Lightweight Installation Agent (LIA) authentication method from native to LDAP in a PowerFlex system that was already deployed. LIA is installed on every node during PowerFlex deployment. LIA is used to upgrade the components on the host on which is it installed and is required for many maintenance operations.
LIA supports both native and LDAP authentication for authorization to upgrade a component. If native authentication was specified for LIA during initial PowerFlex Gateway installation, you can switch LIA authentication to LDAP after PowerFlex deployment.
NOTE:After switching LIA authentication to LDAP, assistance from Customer Support is required to change it back to native authentication.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\