Now that SVM replacement is complete (if it was necessary), commence the upgrade of the
PowerFlex system.
Prerequisites
Ensure that you have all the
PowerFlex RHEL OL7 packages for the
PowerFlex version currently installed in your system, and the latest
PowerFlex v3.6 RHEL OLx packages.
Ensure that you know the media type (SSD or HDD) of the devices in the system's Storage Pools. You will need to supply this information during the upgrade process. This version of
PowerFlex does not allow mixed device types in Storage Pools, so ensure that your Storage Pools are configured accordingly before you upgrade your system.
Ensure that you know the IP addresses and credentials for the
PowerFlex Gateway, MDM and LIA.
About this task
Steps
In command line, upgrade the RPM of the
PowerFlex Gateway to v3.6:
rpm -Uvh <RHELx_GATEWAY_PACKAGE>
From the
PowerFlex plug-in, launch the SVM.
Log in as an admin user.
Using a web browser, go to the
PowerFlex Gateway's IP address, and log into the
PowerFlex Installer.
In the
Packages view, upload the currently installed RHEL OL7 packages, and the target version v3.6 RHEL OLx packages.
In the
Maintain view, enter the primary MDM's IP address, MDM Username (admin user), and MDM password. Enter the LIA authentication type and password. Click
Retrieve system topology.
When you are prompted, approve all the certificates.
At the bottom of the window, click
Upgrade.
When you are prompted to confirm the upgrade, click
Next.
When you are prompted to select the device media type for each Storage Pool, select the appropriate type for each Storage Pool. To continue, click
Proceed.
Retype the MDM password and select your desired settings for the upgrade.
NOTE:SDC upgrade is performed using the
PowerFlex plug-in, and should not be selected now.
Click
Upgrade.
Go to the
Monitor view to follow the progress of the upgrade and to move from one stage of the process to the next.
When the Query phase is complete, click
Start upload phase.
When the Upload phase is complete, click
Start install phase.
When the Install phase is complete, click
Mark operation completed.
In command line, check system status:
scli --query_all
In the returned output:
The MDM cluster state should be optimal.
All SDSs should be connected and running version v3.6.
All SDCs should be connected.
Proceed to the next task.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\