Log in to the
PowerFlex Installer and upload the
PowerFlex installation packages.
Prerequisites
Ensure that you have network access to the software packages that you downloaded and extracted as part of the preparation tasks.
Ensure that you know the password that was defined for the
PowerFlex Gateway.
Steps
Log in to the
PowerFlex Installer:
Point your browser to this URL: https://<GW_Server_IP>
where
<GW_Server_IP> is the IP address of the server where you installed the
PowerFlex Gateway package.
Accept the certificate warning; alternatively, install your own certificate for the Tomcat server.
Enter the default user name,
admin, and the password defined when the
PowerFlex Gateway was prepared, and then click
Login.
Upload installation packages:
At the top of the
Welcome window, click
Packages.
You may need to re-authenticate.
From the
Manage Installation Packages page, click
Browse, and browse to the extracted
PowerFlex component packages. Select all the required files, and then click
Open.
Select these packages for each operating system type that will be used in your
PowerFlex system:
MDM
SDS
SDC
LIA
RFcache XCACHE package (optional; required for Medium Granularity Storage Pool acceleration)
VASAPROVIDER package (optional; required for VMware vVols)
SDR (optional; required for the replication feature)
Click
Upload.
The uploaded installation packages appear in the packages table.
Click
Proceed to Install.
Results
The
PowerFlex software packages have been uploaded to the
PowerFlex Installer, in preparation for deployment. In the next task, you will use the
PowerFlex Installer to install the software on the nodes.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\