When deploying SDC nodes on a Linux or Windows server in a two-layer environment, add rows to the CSV file specifically for SDCs, that only contain the values listed in this table.
Table 1. CSV topology spreadsheet—Two-layer
Field
Description
Required
Domain
If using a domain user, the name of the domain (not relevant for Linux)
Username
The name of the user.
Linux nodes: Enter either
root or a non-root sudo user, indicated by appending "(sudo)" to the end of the username (default:
root). For more information on deploying with a non-root user, see "Deployment of a non-root user".
Windows nodes: Enter a user with administrator rights (default:
administrator).
Password
Password used to log in to the node. This should be the password of the user entered in the
Username column.
To authenticate with SSH instead of node passwords, see "Using SSH authentication on the
PowerFlex Gateway.
Yes
Operating System
The server’s operating system:
linux or
windows
Yes
SDS-SDC Only IPs
SDC IP addresses to be used for communication among SDS and SDC nodes only. Comma-separated, no spaces.
NOTE: For SDC-only nodes, enter the IP address in this column.
Is SDC
Yes
Yes
perfProfileForSDC
Optional performance profile to set for SDCs:
High (default) or
Compact. When this field is left empty, the default option is applied. High performance is required for the Fine Granularity data layout feature. For more information, see "Configure performance profile during deployment".
SDC Name
Name for the SDC.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\