- Notes, cautions, and warnings
- Introduction
- Revision history
- PowerFlex overview
- System requirements and product limits
- Architecture
- System
- MDM cluster
- Virtual IP addresses
- Storage definitions
- Storage pools
- Acceleration pools
- Data layout
- Volumes
- Naming PowerFlex objects
- NVMe over TCP overview
- PowerFlex file services
- Replication
- Replication peer systems
- Storage data replicator
- Journal
- Replication consistency group
- Replication pairs
- Recovery point objective
- Replication I/O flow
- Replication auto-provision
- Replication initial copy
- Activating or terminating a replication consistency group
- Pausing replication
- Using replicated volumes
- Accessing target volumes
- Setting up replication
- Dell APEX Block Storage
- Protection and load balancing
- Cache
- Networking requirements and limitations
- SDC connection monitoring
- SMART hardware monitoring
- Snapshots
- Performance
- Migrating volumes
- Implementing PowerFlex
- Additional functions
- Maintenance
- PowerFlex management
- Configure direct attached storage
Dell PowerFlex 4.6.x Technical Overview
Replication auto-provision
PowerFlex supports automatic creation and mapping of a volume in the peer system.
For a given volume on the source system, you can:
- Create a volume on the destination system.
- Create a replication pair for the given source volume and the new destination volume.
In addition, you can request to map the destination volume to an SDC.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\