- Notes, cautions, and warnings
- Introduction
- Revision history
- PowerFlex overview
- System requirements and product limits
- Architecture
- System
- MDM cluster
- Virtual IP addresses
- Storage definitions
- Storage pools
- Acceleration pools
- Data layout
- Volumes
- Naming PowerFlex objects
- NVMe over TCP overview
- PowerFlex file services
- Replication
- Replication peer systems
- Storage data replicator
- Journal
- Replication consistency group
- Replication pairs
- Recovery point objective
- Replication I/O flow
- Replication auto-provision
- Replication initial copy
- Activating or terminating a replication consistency group
- Pausing replication
- Using replicated volumes
- Accessing target volumes
- Setting up replication
- Dell APEX Block Storage
- Protection and load balancing
- Cache
- Networking requirements and limitations
- SDC connection monitoring
- SMART hardware monitoring
- Snapshots
- Performance
- Migrating volumes
- Implementing PowerFlex
- Additional functions
- Maintenance
- PowerFlex management
- Configure direct attached storage
Dell PowerFlex 4.6.x Technical Overview
Performance
PowerFlex is a scale-out, high-performance storage system. The performance of the system is almost perfectly scalable, as shown in the graph. This means that adding nodes adds capacity and also increases the performance of the system.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\