Add SDRs, at least two per protection domain that has replicated volumes.
Perform the following steps to configure replication:
Create Replication Consistency Group. Define RPO.
Add volume pairs. Volumes in a volume pair must have the same size. It is not necessary but is recommended that they have the same attributes (medium/fine granularity, zero padded/non-zero padded).
If both systems are 4.x or higher then the target volumes may be automatically provisioned when the pair is created.
If the RCG was created as active (the default) then initial copy is started automatically. Otherwise, the RCG must be activated before initial copy is started.
For additional information about replication, see the
PowerFlex 4.5.x Administration Guide.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\