- Notes, cautions, and warnings
- Introduction
- Revision history
- PowerFlex overview
- System requirements and product limits
- Architecture
- System
- MDM cluster
- Virtual IP addresses
- Storage definitions
- Storage pools
- Acceleration pools
- Data layout
- Volumes
- Naming PowerFlex objects
- NVMe over TCP overview
- PowerFlex file services
- Replication
- Replication peer systems
- Storage data replicator
- Journal
- Replication consistency group
- Replication pairs
- Recovery point objective
- Replication I/O flow
- Replication auto-provision
- Replication initial copy
- Activating or terminating a replication consistency group
- Pause replication
- Using replicated volumes
- Accessing target volumes
- Setting up replication
- Dell APEX Block Storage
- Protection and load balancing
- Cache
- Networking
- SDC connection monitoring
- SMART hardware monitoring
- Snapshots
- Performance
- Migrating volumes
- Implementing PowerFlex
- Additional functions
- Maintenance
- PowerFlex management
- Configure direct attached storage
Dell PowerFlex 4.5.x Technical Overview
PowerFlex file services improvements
PowerFlex Manager introduces the following PowerFlex file services enhancements:
Single namespace
- Ability to create a global namespace (GNS) supported by the NAS cluster with a single export
- Allows all hosts with correct access permission to access existing and newly added file systems to the namespace without needing to explicitly mount them on each client
- Consists of several file systems that may be SMB or NFS
Common Event Publishing Agent
- Support for Common Event Publishing Agent (CEPA), which is part of the Common Event Enabler (CEE) package
- Ability to receive file event notifications
- Ability to use CEPA to see events on some or all of my NFS and SMB file systems.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\