- Notes, cautions, and warnings
- Introduction
- Revision history
- PowerFlex overview
- System requirements and product limits
- Architecture
- System
- MDM cluster
- Virtual IP addresses
- Storage definitions
- Storage pools
- Acceleration pools
- Data layout
- Volumes
- Naming PowerFlex objects
- NVMe over TCP overview
- PowerFlex file services
- Replication
- Replication peer systems
- Storage data replicator
- Journal
- Replication consistency group
- Replication pairs
- Recovery point objective
- Replication I/O flow
- Replication auto-provision
- Replication initial copy
- Activating or terminating a replication consistency group
- Pause replication
- Using replicated volumes
- Accessing target volumes
- Setting up replication
- Dell APEX Block Storage
- Protection and load balancing
- Cache
- Networking
- SDC connection monitoring
- SMART hardware monitoring
- Snapshots
- Performance
- Migrating volumes
- Implementing PowerFlex
- Additional functions
- Maintenance
- PowerFlex management
- Configure direct attached storage
Dell PowerFlex 4.5.x Technical Overview
Support for Dell PowerEdge R660, R760, R6625, and R7625 servers
PowerFlex 4.5 certifies support of the following platforms for software only and custom node offerings:
-
Dell PowerEdge R660 and
Dell PowerEdge R760 servers (Intel based)
- Available with a new persistent memory solution, Software Defined Persistent Memory (SDPM)
- Dell PowerEdge R6625 and Dell PowerEdge R7625 servers (AMD based)
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\