Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell PowerEdge Systems Red Hat Enterprise Linux 9 Installation Guide

PDF

Install Red Hat Enterprise Linux 9 on FCoE-enabled storage

About this task

CAUTION Ensure that you back up all the data from the system before installing or upgrading the operating system.
NOTE The fcoe.ko kernel module is no longer available for creating software FCoE interfaces over Ethernet adapters and drivers. RHEL 9 installation is supported only using Converged Network Adapters (CNAs) that use hardware offload.

Steps

  1. Select the installation destination in the Installation Destination window.
  2. Click Add a disk in the Specialized & Network Disks section.
  3. Click Add FCoE SAN, and then click Add Drive.
    The Configure FCoE Parameters window is displayed.
  4. Select the network interface that is connected to your FCoE switch, and then click Add FCoE Disk(s).

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\