Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products

Precision 7960 Tower Service Manual

Installing the PCIe holder

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following images indicate the location of the PCIe holder and provide a visual representation of the installation procedure.

Installing the front bezel

Steps

  1. Align and place the PCIe holder on the slot over the front-fan assembly and fasten the clips to secure it with the chassis.
  2. Open the PCIe-holder press cover and route all the VGA cables through the routing guides.
  3. Close the PCIe-holder press cover.

Next steps

  1. Install the air shroud.
  2. Install the left-side cover.
  3. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\