- Notes, cautions, and warnings
- Working on Your Computer
- Removing and
installing components
- Recommended Tools
- System Overview
- Removing the Power Supply Unit (PSU)
- Installing the Power Supply Unit (PSU)
- Removing the Front Cover
- Installing the Front Cover
- Removing the Hard Drive
- Installing the Hard Drive
- Removing the Left Cover
- Installing the Left Cover
- Removing the Intrusion Switch
- Installing the Intrusion Switch
- Removing the PCI Card
- Installing the PCI Card
- Removing the Slimline Optical Drive
- Installing the Slimline Optical Drive
- Removing the Memory Shroud
- Installing the Memory Shroud
- Removing the Memory
- Installing the Memory
- Removing the Coin-Cell Battery
- Installing the Coin-Cell Battery
- Removing the Heatsink
- Installing the Heatsink
- Removing the Liquid Cooler Heatsink (Optional)
- Installing the Liquid Cooler Heatsink (Optional)
- Removing the HeatSink Fan
- Installing the Heatsink Fan
- Removing the PCIe Card Retention
- Installing the PCIe card retention
- Removing the System-Fan Assembly
- Installing the System-Fan Assembly
- Removing the Front Bezel
- Installing the Front Bezel
- Removing the I/O Panel and the USB 3.0 Ports
- Installing the I/O Panel and the USB 3.0 Ports
- Removing the Power Switch
- Installing the Power Switch
- Removing the Speaker
- Installing the Speaker
- Removing the Right Cover
- Installing the Right Cover
- Removing the 5.25-inch Optical Drive
- Installing the 5.25-inch Optical Drive
- Removing the HDD Thermal Sensor
- Installing the HDD Thermal Sensor
- Removing the Processor
- Installing the Processor
- Removing the Hard-Drive Fan
- Installing the Hard-Drive Fan
- Removing the Power Supply Unit (PSU) Card
- Installing the Power Supply Unit (PSU) Card
- System Board Components
- Removing the System Board
- Installing the System Board
- Additional Information
- System Setup
- Diagnostics
- Troubleshooting your computer
- Technical Specifications
- Contacting Dell
Dell Precision Tower 7910 Owner's Manual
Installing the Intrusion Switch
- Install the intrusion switch into its place holder on the chassis.
- Route the intrusion-switch cable around the chassis clips and install the connector to the system board.
- Install:
- Follow the procedures in After Working Inside Your Computer .
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\