The system's software security features include a system
password and a setup password. The password jumper disables any password(s)
currently in use. There are 2–pins for the PSWD jumper.
NOTE:The password jumper
is disabled by default.
Follow the procedures in Before Working Inside Your
Computer.
Remove the cover.
Identify the PSWD jumper on the system board. For identifying
the PSWD jumper on the system board, see the System Board Components.
Remove the PSWD jumper from the system board.
NOTE:The existing
passwords are not disabled (erased) until the computer boots without
the jumper.
Install the cover.
NOTE:If you
assign a new system and/or setup password with the PSWD jumper installed,
the system disables the new password(s) the next time it boots.
Connect the computer to the electrical outlet and power-on
the computer.
Power-off the computer and disconnect the power cable from
the electrical outlet.
Remove the cover.
Replace the jumper on the pins.
Install the cover.
Follow the procedures in After Working Inside Your Computer.
Power-on the computer.
Go to the system setup, and assign a new system or setup
password.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\