Precision 7960 Rack Service Manual

1. Follow the procedure in Before working inside your computer.
   NOTE:Your computer’s Service Tag is stored in the system board. You must enter the Service Tag in the BIOS setup program after you replace the system board.
   NOTE:Replacing the system board removes any changes that you have made to the BIOS using the BIOS setup program. You must make the appropriate changes again after you replace the system board.
   NOTE:Before disconnecting the cables from the system board, note the location of the connectors so that you can reconnect the cables correctly after you replace the system board.
2. Remove the system cover.
3. Remove the air shroud.
4. Remove the cooling fan assembly.
5. Remove the left control panel.
6. Remove the right control panel.
7. Remove the left wall bracket.
8. Remove the right wall bracket.
9. Remove the memory module.
10. Remove the riser card 1.
11. Remove the riser card 3.
12. Remove the riser card 2.
13. Remove the riser card 4.
14. Remove the processors and heat-sink module.
15. Remove the system board.

The following images indicate the location of the LOM card and provide a visual representation of the removal procedure.