- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- System cover
- Cooling fan assembly
- Cooling fans
- Hard drive assembly
- Air shroud
- Processors and heat sinks
- Coin-cell battery
- Backplane cover
- Front PowerEdge RAID Controller (PERC) module
- Hard drive backplane
- Left control panel
- Right control panel
- Left wall bracket
- Right wall bracket
- Open Compute Project (OCP) card
- Power-supply unit
- Memory modules
- Expansion card
- System board
- Rear I/O card
- LAN on Motherboard (LOM) card
- Drivers and downloads
- BIOS Setup
- Troubleshooting
- Getting help and contacting Dell
Precision 7960 Rack Service Manual
Removing the cooling fan
CAUTION:The cooling fans are hot swappable. To maintain proper cooling while the system is on, replace only one fan at a time.
- Follow the procedure in Before working inside your computer.
- Remove the system cover.
The following images indicate the location of the cooling fan and provide a visual representation of the removal procedure.
Press the orange release tab and lift the cooling fan to disconnect the fan from the connector on the system board.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\