Precision 7960 Rack Service Manual

Removing processor from processor heat-sink module

The following images indicate the location of the processor and provides a visual representation of the removal procedure.

This image shows how to remove the processor

Flex the outer edges of the bracket to release the processor from the bracket.

Place the heat sink with the processor side facing up.
Using your thumb, lift the thermal interface material (TIM) break lever to release the processor from the TIM and retaining clip.
Holding the processor by the edges, lift the processor away from the retaining clip.
NOTE:Ensure to hold the retaining clip to the heat sink as you lift the TIM break lever.
NOTE:Ensure to return the TIM break lever back to original position.
Using your thumb and index finger, first hold the retaining clip release tab at the pin 1 connector, pull out the tip of the retaining clip release tab, and then lift the retaining clip partially from the heat sink.
Repeat the procedure at the remaining three corners of the retaining clip.
After all the corners are released from the heat sink, lift the retaining clip from the pin 1 corner of the heat sink.