- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- System cover
- Cooling fan assembly
- Cooling fans
- Hard drive assembly
- Air shroud
- Processors and heat sinks
- Coin-cell battery
- Backplane cover
- Front PowerEdge RAID Controller (PERC) module
- Hard drive backplane
- Left control panel
- Right control panel
- Left wall bracket
- Right wall bracket
- Open Compute Project (OCP) card
- Power-supply unit
- Memory modules
- Expansion card
- System board
- Rear I/O card
- LAN on Motherboard (LOM) card
- Drivers and downloads
- BIOS Setup
- Troubleshooting
- Getting help and contacting Dell
Precision 7960 Rack Service Manual
Installing the left control panel
If you are replacing a component, remove the existing component before performing the installation procedure.
The following images indicate the location of the left control panel and provide a visual representation of the installation procedure.
- Align and slide the left control panel in the slot on the computer.
- Route the left control panel cable through the side wall of the computer.
- Align and slide the left control panel cable cover in the slot on the system.
NOTE:Route the cable properly to prevent the cable from being pinched or crimped.
- Connect the left control panel cable to its connector on the system board.
- Replace the eight screws to secure the left control panel and the cable cover to the system.
- Install the air shroud.
- Install the cooling fan assembly.
- Install the system cover.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\