- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- System cover
- Cooling fan assembly
- Cooling fans
- Hard drive assembly
- Air shroud
- Processors and heat sinks
- Coin-cell battery
- Backplane cover
- Front PowerEdge RAID Controller (PERC) module
- Hard drive backplane
- Left control panel
- Right control panel
- Left wall bracket
- Right wall bracket
- Open Compute Project (OCP) card
- Power-supply unit
- Memory modules
- Expansion card
- System board
- Rear I/O card
- LAN on Motherboard (LOM) card
- Drivers and downloads
- BIOS Setup
- Troubleshooting
- Getting help and contacting Dell
Precision 7960 Rack Service Manual
Removing the hard-drive from the drive carrier
- Follow the procedure in Before working inside your computer.
The following images indicate the location of the hard-drive from the drive carrier and provide a visual representation of the removal procedure.
- Remove the four screws from the slide rails on the drive carrier.
NOTE:If the drive carrier has Torx screw, use Torx 6 (for 2.5-inch drive) or Torx 8 (for 3.5-inch drive) screwdriver to remove the drive.
- Lift the hard-drive out of the drive carrier.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\