Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell Precision Rack 7910 Owner's Manual

Removing the PCIe card holder

Prerequisites

  1. Ensure that you read the Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. If installed, remove the full-length PCIe card.
CAUTION:Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
CAUTION: Do not use your system without the PCIe card holder installed. The PCIe card holder is necessary to ensure proper system cooling.

Steps

  1. Press the release tab and slide the card holder toward the back of the chassis to release the PCIe card holder from the chassis.
  2. Lift the PCIe card holder out of the chassis.
    NOTE:To ensure proper system cooling, you must replace the PCIe card holder.
    Figure 1. Removing and installing the PCIe card holder
    This figure shows removing and installing the PCIe card holder.
    1. PCIe card holder
    2. release tab

Next steps

  1. Replace the PCIe card holder.
  2. Follow the procedure listed in After working inside your system.

To see a video on how to remove & install a PCI card and riser, search in the quick resource locator database at qrl.dell.com.


Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\