You can use the Boot Settings screen to set the Boot mode to either BIOS or UEFI. It also allows you to specify the
boot order.
About this task
You can view
the Boot Settings screen by clicking System Setup Main Menu > System BIOS > Boot Settings.
The Boot Settings screen details are explained
as follows:
Menu Item
Description
Boot Mode
Enables you to set the boot mode of the system.
CAUTION:Switching
the boot mode may prevent the system from booting if the operating
system is not installed in the same boot mode.
NOTE:Setting this field
to UEFI disables BIOS Boot Settings menu. Setting this field to BIOS disables
the UEFI Boot Settings menu.
If the operating
system supports UEFI, you can set this option to UEFI. Setting this field to BIOS allows compatibility
with non-UEFI operating systems. By default, the Boot Mode option is set to UEFI.
Boot Sequence Retry
Enables or disables the boot sequence retry feature.
If this field is enabled and the system fails to boot, the system
reattempts the boot sequence after 30 seconds. By default, the Boot Sequence Retry option is set to Enabled.
Hard Disk Failover
Specifies which devices in the Hard-Disk
Drive Sequence are attempted in the boot sequence. When
the option is Disabled, only the first hard
disk device in the list is attempted to boot. When set to Enabled, all hard disk devices are attempted in order,
as listed in the Hard-Disk Drive Sequence.
This option is not enabled for UEFI Boot Mode.
UEFI Boot Sequence
This field controls the UEFI boot order
Integrated
NIC 1 Port 1 Partition 1
Boot option Enable/Disable
This field enables or disables the boot option in
UEFI Boot Sequence.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\