- Notes, cautions, and warnings
- Working inside your computer
- Disassembly and reassembly
- Recommended tools
- Screw List
- Major components of your system
- Side cover
- Power-supply unit cage
- Front bezel
- Memory modules
- Solid-state drive
- 2.5-inch hard drive
- 3.5-inch hard drive
- AIC WLAN card
- WLAN card
- Slim optical-drive
- Expansion Card
- System fan
- Coin-cell battery
- Processor fan and heat-sink assembly
- Processor
- Voltage regulator heat sink
- Power button
- Intrusion switch
- Front I/O panel
- System board
- Drivers and downloads
- System setup
- Troubleshooting
- Getting help and contacting Dell
Precision 3650 Tower Service Manual
Removing the side cover
Prerequisites
- Follow the procedure in
before working inside your computer.
NOTE:Ensure that you remove the security cable from the security-cable slot (if applicable).
About this task
The following images indicate the location of the side cover and provide a visual representation of the removal procedure.
Steps
- Remove the single screw (M6.32x12.7) to unlock the release latch.
- Pull the release latch to release the side cover from the computer.
- Open the side cover towards the side of the computer and lift the cover away from the computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\