- Notes, cautions, and warnings
- Working inside your computer
- Disassembly and reassembly
- Recommended tools
- Screw List
- Major components of your system
- Side cover
- Power-supply unit cage
- Front bezel
- Memory modules
- Solid-state drive
- 2.5-inch hard drive
- 3.5-inch hard drive
- AIC WLAN card
- WLAN card
- Slim optical-drive
- Expansion Card
- System fan
- Coin-cell battery
- Processor fan and heat-sink assembly
- Processor
- Voltage regulator heat sink
- Power button
- Intrusion switch
- Front I/O panel
- System board
- Drivers and downloads
- System setup
- Troubleshooting
- Getting help and contacting Dell
Precision 3650 Tower Service Manual
Installing the IO panel
Prerequisites
About this task
The following image indicates the location of the intrusion switch and provides a visual representation of the installation procedure.
Steps
- Insert the IO panel into its slot and slide the to secure it into the slot.
- Replace the single (#6-32) screw that secures the IO panel to the computer chassis.
- Connect the IO audio, SD card (optional), USB Type-C and IO USB cables to the connector on the system board.
Next steps
- Close the PSU cage.
- Install the front bezel.
- Install the side cover.
- Follow the procedure in after working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\