Precision 3640 Tower Service Manual

Loading, Please wait

Installing the heatsink assembly

If you are replacing a component, remove the existing component before performing the installation process.

The following images indicate the location of the heatsink assembly and provides a visual representation of the installation procedure.

Replace the heatsink assembly on the top of processor preassembled with thermal gel.
NOTE:Tighten the screws in a sequential order (1,2,3,4) as mentioned on the system board.
Tighten the four captive screws that secure the heat sink assembly and lift it from the computer.
Replace the system fan on top of the heat sink assembly and tighten the four captive screws and connect the fan cable to the system board.

Thank you for your feedback.

Please provide ratings (1-5 stars).

Please select whether the article was helpful or not.

Comments cannot contain these special characters: <>()\